AMT Datasouth Fastmark M5 Plus Series Guide de l'utilisateur télécharger pdf (Page 38)

Document #120522 Rev-A

Ribbon Sensor and

Gap/Black Mark

Sensor Calibration

1. Turn off the power switch.

2. Hold on the button then turn on the power switch.

3 Release the button when LED becomes red and blinking.

(Any red will do during the 5 blinks).

 It will calibrate the ribbon sensor and gap/black mark

sensor sensitivity.

 The LED color will be changed as following order

Amber  red (5 blinks)  amber (5 blinks)  green

(5 blinks)  green/amber (5 blinks)  red/amber (5

blinks)  solid green

Note:

Please select gap or black mark sensor by GAP or BLINE

command prior to calibrate the sensor.

For more information about GAP and BLINE command,

please refer to programming manual.

Gap/Black Mark

Sensor Calibratio,

Label Length

Measurement,

Self Test and enter

Dump Mode

1.Turn off the power switch.

2. Hold on the button then turn on the power switch.

3. Release the button when LED becomes amber and

blinking. (Any amber will do during the 5 blinks).

 The LED color will be changed as following order.

Amber  red (5 blinks)  amber (5 blinks)  green

(5 blinks)  green/amber (5 blinks)  red/amber (5

blinks)  solid green

 It calibrates the sensor and measures the label

length and prints internal settings then enter the

dump mode.

Note:

Please select gap or black mark sensor by GAP or BLINE

command prior to calibrate the sensor.

For more information about GAP and BLINE command,

please refer to programming manual.

1 2 ... 33 34 35 36 37 38 39 40 41 42

Pas de commentaire

AMT Datasouth Fastmark M5 Plus Series Guide de l'utilisateur Page 38