AMT Datasouth Fastmark M5 Plus Series Guide de l'utilisateur télécharger pdf (Page 21)

Document #120522 Rev-A

5. Turn over the printer. Remove two screws located near the top cover hinge.

6. Remove the screw from the memory card cover, and left the cover off. Plug in

the cutter driver IC at U14 (M5) / U30 (M5 PLUS) socket on the main board.

7. Use both thumbs to hold the lower cover and index fingers to lift up the top

cover open levers to separate the lower inner cover and the lower cover.

8. Thread the cable through the bezel. Connect the cutter module cable to the

4-pin socket on printer PCB.

Fig. 24 Cutter module installation

Fig. 25 Cutter module cable arrangement

PCB

4-pin Socket

Cutter Cable

Cutter

Lower Inner Cover

Lower CoverCutter Cable

Bezel

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 41 42

Pas de commentaire

AMT Datasouth Fastmark M5 Plus Series Guide de l'utilisateur Page 21