AMT Datasouth Fastmark M6 PLUS Series Guide de l'utilisateur télécharger pdf (Page 31)

2.7 Print Head Pressure Adjustment Knob



There are two conditions that will need to adjust the print head pressure.

1. Print with thick media

If the media thickness is larger than 0.19 mm, the larger pressure is required to get good

quality printout.

2. Print with narrow media

If the media width is less than 4 inch wide the print head pressure will need to be adjusted to

avoid ribbon wrinkle.

There are 5 levels of pressure for adjustment. Level 1 is the minimum pressure and level 5 is the

maximum pressure.

For example, if the label width is 4 inch, adjust both print head pressure adjustment knobs to the

same level. If the label is less than 2 inch wide, increase the left side print head pressure by rotating

the adjustment knob clockwise and decrease the right side pressure by rotating the adjustment knob

counter-clockwise to level 1.



1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 82 83

Pas de commentaire

AMT Datasouth Fastmark M6 PLUS Series Guide de l'utilisateur Page 31