AMT Datasouth 600 Manuel d'utilisateur télécharger pdf

Technical Bulletin

N3300/N600 NETWORK PRINTER PRODUCT INFORMATION

Part No. BBF-104671 Rev. A

This document describes the features available for N3300 and N600 Series printers. This

information is supplemental to the printer User Manual and the N-Series Network Installation and

User Guide.

NOTE:

The Serial configuration cable must be installed with the printer baud rate set to 9600 to

access network related features.

The connection on the N-Series network interface cover labeled Serial is connected to the printer

serial port and is used for communicating both print jobs and configuration. If the cable connecting

the network interface to the printer serial port is disconnected, the following message will appear

in the display of the printer when attempting to access network related features using the keypad:

"<Config Error>"

"Check Serial I/F"

The printer will function if configured properly; however, no LAN setup features can be accessed.

Menu Updates

NOTE:

The M6 PARALLEL CTRL menu in the N3300 (G5 PARALLEL CNTRL in the

N600) has been renamed to NETWORK CTRL. The parallel features are still

available at the end of this menu.

Under M6 (G5) NETWORK CTRL

the following features are available:

Enter Password

Print LAN Config

Set IP Address

Set Subnet Mask

Set Gateway

Run Loop Back

These features are not displayed unless the correct password has been entered.

Network Control Menu features may also be accessed using the Quick Access key on the N3300 Series.

1 2 3 4 5 6 ... 14 15

Résumé du contenu

Page 1 - Menu Updates

1Technical BulletinN3300/N600 NETWORK PRINTER PRODUCT INFORMATIONPart No. BBF-104671 Rev. AThis document describes the features available for N3300 an

Page 2 - Entering Passwords

10Port Timeout FeatureThe Port Time feature controls how port contention is handled.Display:"Port Time 8s"Description:This feature allo

Page 3

11NOTE:Altering the configuration of the active interface in DPCL mode may cause loss ofcommunication with the host computer.The following is a summar

Page 4 - Setting the IP address

12Table 2 DPCL Command Sequences (cont.)ASCII Command DPCL EmulationCommand DescriptionI21;P1. Ribbon Replace Limit (Performax)I22;P1. Ribbon Life Li

Page 5 - Setting Subnet Mask

13Table 2 DPCL Command Sequences (cont.)ASCII Command DPCL EmulationCommand DescriptionR12;P1. Execute Mode TestR13;P1 P2. Execute Self TestR14;P1 P2

Page 6 - Running the Loop Back Test

14Table 2 DPCL Command Sequences (cont.)ASCII Command DPCL EmulationCommand DescriptionE4;P1. Symbol SetE5;P1. NationalityE6;P1. Slashed ZeroesE7;P1.

Page 7 - Virtual Forms Selection

15This information supercedes information of like content in the Printer UserManual (BBF-104431).Under M2 Personality the TI-885 Emulation and the Hel

Page 8

2Under M7 PROFILE CNTRL (N3300 Series ONLY) the following features are available:(for more information refer to N3300 Features discussed later in this

Page 9

3To enter a password:1. N3300: Select the “Enter Password” by opening the keypad setup door and pressingthe Quick Access key once.A600: Press the Off

Page 10 - Port Timeout Feature

4Printing Network configurationsA network configuration print out feature is available to aid installation and troubleshooting. This feature has seve

Page 11

5Example setting IP address to 138.254.132.120:Keypad DisplaySelect the Set IP Address feature. Set IP AddressPress Value keys to scroll the active nu

Page 12

6Setting the Default GatewayThe same procedure used to set the IP address is used to set the Default GatewaySet GatewayNote the first character change

Page 13

7THE REMAINING INFORMATION IS ONLY VALID FOR THE N3300SERIES PRINTERS.Virtual Forms SelectionThe Virtual Forms Selection (VFS) capability on the N3300

Page 14

8Profile Select Feature via Serial/Parallel PortThe Parallel Port feature (Par Prt Off) specifies which profile is automatically selectedwhen a new pr

Page 15 - Manual (BBF-104431)

9Example using VFS features in a Novell environment:This example shows the N3302 printer with Ethernet address 00-c9-00-00-50-08 installedas a NetWare